Connect to DSAM Serial Targets via SSH

See Supported CLI Commands.

• To connect to DSAM serial targets via SSH:

1. Make sure that SSH Access is enabled in Device Settings > Network Services > SSH.
2. Launch SSH client in client PC to connect to Dominion KX IV–101.
3. After login, user will enter CLI interface.
4. Type command "connect <serial port number>".

   Example: connect 1.4

5. If successful, serial target is accessed.
6. To exit serial target, type escape-key-sequence, default is Ctrl-], then enter port sub-menu CLI interface.
7. Type "close", then enter main CLI interface.