Restarting CC-SG

The restart command is used to restart the CC-SG software. Restarting CC-SG will log all active users out of CC-SG.

Restarting will not cycle power to the CC-SG. To perform a full reboot, you must access Diagnostic Console or the power switch on the CC-SG unit.

1. Choose System Maintenance > Restart.
2. Type your password in the Password field.
3. Broadcast message: Use the default message or edit it. The message will display to users who will be logged off CC-SG.
4. Restart after (min): Enter the number of minutes (from 0-720) that should elapse before CC-SG restarts.

   If specifying over 10 minutes, the broadcast message displays to users immediately, and then repeats at 10 and 5 minutes before the event occurs.

5. Click OK to restart CC-SG.