Configuring Powerstrips that are Managed by Another Device in CC-SG

In CC-SG, managed powerstrips can be connected to one of the following devices:

• Dominion KX
• Dominion KX2
• Dominion KX2-101
• Dominion SX 3.0
• Dominion SX 3.1
• Dominion KSX
• Dominion KSX2
• Paragon II/Paragon II System Controller (P2SC)
• Power IQ - See Power Control of Power IQ IT Devices

You must know which Raritan device the managed powerstrip is connected to physically.

Note: You can also have a Dominion PX powerstrip that is connected to your IP network, but not connected to any other Raritan device. See Managed PowerStrips for details on configuring power control for these powerstrips.

• To configure managed powerstrips in CC-SG:

1. Complete all physical connections between the device, the powerstrip, and the nodes that are powered by the powerstrip. See the RPC Quick Setup Guide, Dominion PX Quick Setup Guide, and CC-SG Deployment Guide for details on physical connections between powerstrips, devices, and nodes.
2. Add the managing device to CC-SG. The procedure varies for different Raritan devices. See the section that corresponds to the device the powerstrip is connected to:
   • Configuring PowerStrips Connected to KX, KX2, KX2-101, KSX2, and P2SC
   • Configuring PowerStrips Connected to SX 3.0 and KSX
   • Configuring PowerStrips Connected to SX 3.1.
3. Configure outlets. See Configuring Outlets on a PowerStrip.
4. Associate each outlet with the node that it powers. See Interfaces for Managed Powerstrip Connections.