A server can have up to four power plugs and you can associate a different power strip with each. From the Port page, you can define those associations so that you can power on, power off, and power cycle the server.
The KVM and serial Port pages are different from each other with the exception of the Name and Port Association sections. Since the Power Association sections are the same, the steps below apply to both KVM and serial target servers.
To make power associations (associate power strip outlets to target servers):
Note: When a power strip is associated to a target server (port), the outlet name is replaced by the target server name (even if you assigned another name to the outlet).
To remove a power strip association: