Setup for IP Isolation Mode

• Setup for IP Isolation mode:

When implementing IP Isolation mode for your CC-SG network:

• Each CC-SG LAN port must be connected to a different sub-network.
• Raritan devices must be connected to the Primary LAN only.
• Clients to be isolated are connected to the Secondary LAN. Clients that don’t need to be isolated may be connected to the Primary LAN. See Configure a Combination of Direct Mode and Proxy Mode.

  Note: Isolated clients on the Secondary LAN will use Proxy mode. The clients on the Primary LAN may use Direct mode. Set the connection mode to "Both" to configure this combination.

• Specify at most one Default Gateway in the Network Setup panel in CC-SG. Use Diagnostic Console to add more static routes if needed. See Edit Static Routes.